Free in-home measure and quote - PGT, CGI and CWS impact lines compared on your actual openings, style by style
CWS Sliding & Patio Doors: The Westgate Owner’s Guide
If your CWS sliding or patio door is sticking, leaking, or off its track, we can match the part, price it honestly, and install it fast. Most CWS-compatible roller assemblies, handles, locks, and weatherstripping run $85 to $410 installed here in Westgate, with full door replacements typically landing between $2,800 and $7,500 depending on size and impact rating. You’ll usually know the part failed before you see it: the door grinds instead of slides, you feel a draft even when it’s latched, or the lock doesn’t catch the way it used to.
We stock common CWS parts on the truck for same-day repair, and we can source anything oddball within a few days. My name’s on the truck. If it’s not right, I’ll make it right.
Key takeaways:
- We’re an independent installer, not a CWS dealer, which means we match parts to your door rather than pushing a replacement you don’t need.
- Most rollers, locks, and handles are repaired same-day; full CWS door swaps take 1-3 days once the unit arrives.
- Every part and every install is backed by the Done Right Promise.
Which CWS Models This Applies To
CWS sliding and patio doors come in a handful of frame profiles and roller types, and matching the part to the series is where most owners get tripped up. The CWS 7800 and 7900 series sliding doors use a heavier roller carriage than the older 7500 series, and swapping in the wrong one either leaves the door sitting too high or dragging on the track. The surest way to identify what you have is to look for the CWS sticker on the top rail or the glass corner; if that’s faded off after a decade of Westgate sun, we measure the stile width and roller housing, then match from there.
For most wear parts, OEM is the right call on CWS doors under 10 years old. The factory roller assemblies and keepers are dimensioned tighter than generic replacements we’ve tested, and that matters when a sliding panel weighs 300 pounds plus glass. On older units where CWS has discontinued the exact part, we’ll use a quality aftermarket equivalent only if the dimensions and load rating match or exceed the original, and we’ll tell you before we do it.
We also carry compatible hardware for PGT, CGI, and ES Windows sliding doors, so if your home has a mixed brand situation, one call covers it.
Signs Your CWS Sliding & Patio Doors Is Failing
- The door suddenly takes both hands to move. Roller bearings wear flat over time, and once they stop rolling, the panel is grinding metal on metal. This is the most common CWS repair we do in Westgate, and the fix is usually a new roller set, not a new door.
- You can see daylight through the weatherstripping or feel air moving around the panel. The rubber bulb and pile brush on CWS doors flatten and harden in Florida heat, especially on west-facing elevations. Once it’s hard, it stops sealing and starts letting in humidity, dust, and bugs.
- The lock won’t throw or the keeper is visibly bent. A door that sags from worn rollers hits the keeper off-center, and over time the lock bar peens the metal. Replacing the lock without fixing the sag means you’ll replace it again in 18 months.
- You hear a rattle or grinding when the door moves. Debris in the track plus worn wheel bearings is the usual cause, but occasionally a glass pack shifts and expands from thermal stress. We see this on CWS doors 12 to 15 years old, especially where the sun hits the frame directly all afternoon.
- The panel jumps or sticks at one spot along the track. That’s usually a bent or bowed track section, not the door. In Westgate homes where the slab has settled even a fraction of an inch, the track flexes and the door follows it.
Replacement Cost & What’s Included
Here’s what CWS sliding door repairs typically run in Westgate, parts and labor included:
| Repair | Typical Installed Price |
|---|---|
| Roller assembly replacement (sliding panel) | $180-$340 |
| Handle and latch set replacement | $85-$210 |
| Lock and keeper replacement | $120-$240 |
| Weatherstripping replacement (full door) | $90-$220 |
| Track adjustment or minor realignment | $140-$310 |
| Full CWS sliding or patio door replacement | $2,800-$7,500 |
What moves the price: whether you have an impact-rated CWS unit (they’re heavier and pricier to refit), the panel size, and how much track cleanup or frame shimming is needed once we get the old parts out. Every quote is line-itemed and fixed, so the number we give you is the number on the invoice. No change orders because we discovered something we should have caught the first time. Seniors and veterans save 10% on everything, and any repair over $200 takes $40 off automatically.
We also honor a free second opinion on any written estimate from another company, and there’s no trip charge anywhere in our home county.
DIY or Call Us?
There are a few things any Westgate homeowner can check safely before you pick up the phone. Run a finger along the bottom track, and if you feel grit or pebbles, vacuum it out and see if the door improves. Check whether the screws in the handle set have backed out, since loose escutcheon screws on CWS hardware are common and take two minutes to tighten. If the door is just slightly draggy in the morning but fine by noon, the aluminum frame is expanding with the heat and that’s normal Florida behavior, not a part failure.
Here’s where DIY goes wrong. Removing a CWS sliding panel to reach the rollers is a two-person job once the glass gets over 200 pounds, and dropping a panel in a finished Westgate living room costs far more than our service call would have. If the track is bent, the frame is pulling away, or the glass itself is fogged or cracked, leave it alone and call us. We’ll come out, diagnose it for free inside the county, and you’ll know exactly what it costs before any work starts. Call (561) 468-6136.
FAQs
A properly maintained CWS sliding door lasts 20 to 25 years in Westgate’s climate, though weatherstripping and rollers typically need replacement every 7 to 10 years. Homes with west-facing exposure or sliding doors that catch full afternoon sun wear seals faster. Regular track cleaning and prompt roller replacement when the door first gets heavy extends the life of the whole unit. Call (561) 468-6136 for an exact assessment.
Yes, and that’s the first thing we try. If the frame is square and the glass is solid, rollers, locks, handles, and weatherstripping are all repairable parts. We only discuss full replacement when the frame is rotted or bowed, the glass seal has failed and fogged, or the cost of the repair approaches half the cost of a new door. Call (561) 468-6136 for a straight answer.
Most roller, lock, handle, and weatherstripping repairs take 1 to 2 hours on site. Full CWS door replacements are usually completed in one to three days from the time the unit is delivered, depending on framing work. We stock common CWS parts on the truck, so same-day repair is realistic for most Westgate calls. Call (561) 468-6136 to confirm availability.
We keep the most common CWS roller assemblies, handles, locks, and weatherstripping on the truck for same-day work. For less common parts that CWS still distributes, we order directly and have them in hand within a few days. You’ll never need to hunt down parts yourself or guess at a model number. Call (561) 468-6136 and we’ll match it for you.
Ready to Fix Your CWS Door?
Ed Winslow founded Winslow Windows & Doors in 2011, and we’ve been fixing and installing CWS sliding and patio doors in Westgate and the surrounding communities ever since. We’re locally owned, licensed, and insured, with a published address and a phone number answered by a live person 24 hours a day. Every technician who arrives at your door is background-checked and in uniform. The work is done right, or we come back until it is. Call (561) 468-6136 for a free estimate on your CWS sliding or patio door repair. The one down the road.
Written by Ed Winslow, Owner, Winslow Windows & Doors at Winslow Windows & Doors, serving Westgate and nearby areas.
Six Reasons Homeowners Choose Winslow Windows & Doors
Impact systems engineered to design pressures up to +/-100, matched to your wind zone - your openings hold when the storm arrives.
Low-E insulated impact glass from our manufacturer lines commonly cuts monthly cooling bills 20-30%.
Laminated impact glass shuts out up to 40% of outside noise - traffic, neighbors, weather.
Monitoring services run $30-90 a month. Laminated impact glass resists forced entry around the clock, with no subscription.
Florida homeowners average around 25% savings on the windstorm portion of their policy after protecting every opening - some homes qualify for more.
A full impact package upgrades curb appeal, buyer confidence and appraised value in one project.










Before
After
Before
After
Before
After